The Joys of Resin


Items you will need:

  1. Resin
  2. Molds
  3. Measuring cups/stir sticks
  4. Lamp or drink straw
  5. Covered/ventilated work surface
  6. gloves
  7. Items for mold
  8. Sandpaper/blocks
  9. Vaseline
  10. Glaze (optional)

Making bracelets out of resin was one of the first projects I started to broaden my range creatively. I was working on large antique items at the time and felt the need to have something smaller and vibrant to sell. I went to Hobby Lobby and found a plastic bracelet mold and a resin set. You want to make sure to get a decent quality of resin, as well as have mixing/measuring cups and stir sticks that are disposable. I use Alumilite Amazing Clear Casting Kit. 

You can choose any item you wish to put into your molds, as long as they are dry. If you wish to press plants or food items they must be properly dried out, otherwise, your resin may refuse to set and your items could become discolored. Once you have your items ready and workplace set-up, you can begin.

Start by lining your molds lightly with vaseline, this will make the bracelet more removable without damaging your mold. Make sure you wear your gloves once you start dealing with the resin as it could irritate your skin. When I get some on me, I immediately go and wash it off with dish soap and warm water. Follow directions on the proper mixing of the resin, however as long as you mix equal parts of both A and B bottles slowly without removing your stir stick, you should be fine, and won’t get too many bubbles.

Mixing is a slow process that can take a few minutes, the mixture should clear when it is thoroughly mixed. If some bubbles remain, don’t worry, you can attempt to pop them against the side of your mold if you have large bubbles, small ones will have to rise to the surface. Once ready you may pour your resin into the mold half way so that there is room to add your items. Remember that the best side of your bracelet will be the mold set side, not the side you will have to sand, design your bracelet accordingly.

When finished adding your items, top off the mold with more resin so that the top looks smooth. From here you can put a warm light over your mold to bring any bubbles to the surface. I always use a drinking straw and blow quickly onto the mold if I see bubbles close to the surface, the carbon dioxide will make the bubbles pop. Be careful if you try this approach!

Your resin should begin to set quickly, if any items in your mold surface due to air you can push them back down into the mold with your stir stick, however, this will get harder as the resin sets. If you properly mixed your resin the setting process shouldn’t take more than a day or so. If the surface still feels tacky, give it another day to set. Sometimes I have waited up to 3 days due to either imprecise mixing or temperature changes since I make them in my garage.


After they are set, you can bend them out of your mold and get them wet and soapy. That way you can sand them without risk of breathing in particles. Just sand the bottoms and sides till they are smooth and to your liking. Then if you wish you can seal them, I use Sculpey Gloss Glaze, it adds an extra shine and covers any scratches or imperfections. Unfortunately, some bracelets may need another layer of resin brushed on them if the imperfections are too great, such as bubbles that made holes.

I hope this helps anyone who is interested, I know there is much to learn about resin, but as a beginner, this is what I have personally found to be effective. God bless and have fun!